GE Monogram ZV1050 Installation Instructions Manual page 10

Installation Instructions
ISTEP 61 SECURE WIRING
• Route house wiring through the ceiling hole and
pull a length to reach the hood junction box,
approximately 6" below the support.
fy,ing
View
Support
Frames
_______Tape
House
-_ Wiring
• Tape the _dre to the left side of the fl'ame
support to pre_ent damage during installation
aI'ld ser',ice,
ISTEP 71
SIZE AND INSTALL
DUCTWORK
Duct C onnection
ToHood
Side
View
Support
Frame
T
Bottom Support
Frame F lange
Re red
Duct Duct
Dim.A Length
• Measure fl'om house duct flange to bottom of support
fl'ame. Dim. A
- Add at least l" fl)r duct overlap at the top.
- Subtract 1-3/4" for hood insertion into the bottom
of the fl'ame to determine required duct length.
• Cut the 8" duct length required.
Note: The bottom of the duct must be external (female)
c(mnecti(m to the top of the hood. The b()ttom end
sh(mld be flared slightl> to tacilitate installation of the
hood.
• Install duct tip through support fl'ames and attach to
house ducting with sheet metal screws.
• Seal the c(mnection with duct tape.
10