GE ZV950 Installation Instructions Manual page 8

installation Preparation
CHECK iNSTALLATiON HARDWARE
i,ocate the hardware accessory box packed with the
hood and check contents.
8 Wood 4 Wall
Screws Fasteners
2 Large
Flat Washers
2 Mounting Brackets
ggg
3 Phillips Head
Decorative Screws
3 Stainless Steel GreaseFilters
L---16"'?
Duct Cover Bracket
2-piece
Decorative Duct Cover
(dimension shown
for reference only)
i
i
,I_, i
Wall Mount Template
8
DUCTWORK, WIRING LOCATIONS
Determine the exact locadon of the vent hood.
* i,ocate the template packed with the literature.
- Measure
36" from the floor to the top of the cooking
smfhce. Add 25-1/2" (or other recommended space)
f)om the cooking surface to the bottonl of the hood.
Mark that location.
- Use a level to draw a straight pencil line on the wall.
,, /FOR CEILING
6-1/4 ......
_/VENT DUCTING
benterllne /o wall /_,_;
8-1/2" Dia.Hole(
i
i
\\\\\\ i
' Centerline
_,', 8" Min Above
)_Top Mounting
FOR WALLVENTDUCT/[ BracketHoles
i
£
i
W-I
- Tape the template
in position along the penciled
line. CHECK TO BE SURE THE TEMPI,ATE IS
I,EVEI.
Ceiling ducfing:
If duct_,w)rk will vent straight up to the ceiling:
* Use a level to draw a line straight up, f]om the
centerline on the template to the ceiling.
* Measure 6-1/4" flom the back wall to the centerline
of a 8-1/2" hole on the ceiling.
Note: If drywall is not present, add drywall thickness
to the 6-1/4"dimension.
Wall Ducfing:
If ductwork will vent to the rear:
* Use the level to draw a line straight up f_om the
centerline on the template.
* Measure at least S" above the top mot]nfing bracket
boles shown on the template to the centerline of an
8-1/2" dia. duct bole. (Hole may be elongated for
duct elbow.)
HOUSE WIRING LOCATION:
* The junction box is located on the top of the hood,
at the back right side.
* Route house wiring as close to the ceiling location
as possible, through the ceiling, soffit or back wall.
Wiring should enter at least 4" above the bracket
on the right side.