GE ZV950 Installation Instructions Manual page 10

Installation instructions
iNSTALL DUCT BRACKET
The duct bracket must be installed against the ceiling.
This bracket will hold the decorative duct cover in place
at the top.
* Install the 2 small screws into the sides of the duct
bracket. Remove the screws. Pre-tapping the holes will
insme ease of final installation.
Pre-Tap I I I I Pie-Tap
Side ' 'Side
Screw Screw
Secure the bracket to the ceiling and wall:
* Mark tile 4 screw hole locations.
* Drill 1/8" pilot holes in marked bracket location.
* If pilot holes do not enter studs, enlarge tlle holes to
3/8" and install wall fastener anchors.
* Drive screws, by hand, into the fasteners to allow
anchors to expand. Remove tlle screws.
* Secure tlle bracket to the ceiling and wall with wood
screws and/or fasteners.
iNSTALL THE HOOD
Place the hood on the brackets and slide lef_ to right
to align with rectangular slots at the top.
* A( 0 ust the installation height by tightening or
loosening the screws '%" at the bottom of the brackets.
* Align the hood lower mounting holes with pilot holes
in the wall.
* Using two large fiat washers (supplied), install wood
screws or wall fastener screws, loosel 5 into lower
mounting holes. Do not tighten.
LowerMounting Holes
Bracket Tabs
/ Screws _,
/ "B" _
/ ',,
/
* Level the hood by tightening or loosening the screws
"A" located on the bottom
mounting
brackets.
* Tighten lower mounting screws.
* Tighten screws "g" located at the top of the mounting
bracket against the hood to clamp the position.
Do not overfighten screws.
10