GE ZV950 Installation Instructions Manual page 7

installation Preparation
TOOLS AND MATERIALS REQUIRED
{NOT SUPPLIEDI
. Tapemeasure
Knife
Spirit level
Wire cutter/stripper
Wire nuts
Electric drill with 1/8"and 3/8" bits
Phillips and flat blade screwdrivers
. Hammer
. Pliers
. Safety glasses
. Duct tape
.Tape to mount template
. Gloves to protect against sharp edges
.120V 60Hz. 15 or 20 Amp, 2 wire with ground.
Properly grounded branch circuit.
. Strain relief for junction cover.
.8" round metal duct, length to suit installation.
REMOVE THE PACKAGING
The vent hood is shipped secured to a shipping board
with a shipping bracket and 4 screws.
* Remove the duct cove_, parts box and other packaging.
* i,if_ the hood out of the box.
* Remove and properly discard the plastic wrapping.
TopOt Hood
// '_ /
/
/
Junction TopShippingScrews
Box
ScrewsandShippingBracket
* Locate and remove 2 screws at the top of the hood.
Remove 2 screws at the bottom behind the filter
guides on the left and right sides. Remove the
shipping bracket fiom behind the blower housing.
Discard the shipping bracket and board.
* Removej unction box cover
* Install strain relief into junction box cover.