GE ZV950 Installation Instructions Manual page 11

Installation instructions
CONNECT DUCTWORK
. Install ductwork, making connections in direction
of airflow as illustrated.
* Push duct over the exhaust outlet until it reaches
the duct stops.
* Secmejoints in ductwork with sheetmetal screws.
* Wrap all duct joints with duct rope for an airtight seal.
* Use duct tape to seal the flange connection.
CAUTION"
[]Do not use sheet metal screws at
the hood flange connection. Doing so will prevent proper
damper operations. Seal connection with rope only.
PRUDENCE
I1 ne faut pas utiliser de vis autoraurdeuses _'_ la connexion
du collet de la hotte. Ceci emp6cherait le bon
fonctionnement du registre. N'udliser que du ruban
adh6sif pour assurer l'&anch_it6 du raccord.
Duct T ape
Over Seam
ii
L
W
Duct Stops __
CON NECT ELECTRICAL
Verify that power is turned off at the source.
WARNING"
[] If house wiring is not 2-wire
with a ground wire, a ground must be provided by the
installer When house wiring is ahuninmn, be sure to use
U.L. approved anti-oxidant compound and aluminmn-to-
copper
connec[ois.
AVERTISSENIENT
Si la maison n'est pas ci'd)16e avec deux ills et un fil de
terre, l'insmllateur dolt installer un fil de tene. Quand
les ills sont en aluminimn, i1 faut prendre soin d'utiliser
des connecteurs aluminimn k cuiwe avec une p;'_te anti-
oxydante approuv6e par UL.
* Insert house wiring through strain relief and tighten.
* Connect white leads to branch chcuit white lead.
* Connect black leads to branch chcuit black lead.
* Connect green/yellow leads to branch chcuit green
lead or bare ground lead.
* Secure all connections with wire nuts on each electrical
connector.
* Push wires into junction box and replace cover. Be sme
wires are not pinched.
iNSTALL DUCT COVERS
Mounting Screws
* Place the decorative duct
covers on top of the hood.
* Insert the lower portion
of the duct cover into the
impressions on the top of
the hood.
Bottom
Notches
* Extend the inner duct upwards to the ceiling bracket.
* Secure the duct cover to the bracket with the 2 small
Phillips screws provided.
* Install the decorative screw in the lower lef* hole on the
duct cover
as shown.
11