GE Monogram ZV48T Installation Instructions Manual page 12

mnstaaiation mnstructions
ISTEP 2B] AJtemate Mounting Method
iNSTALL HOOD TO SOFNT OF{ BENEATH CABINETS
• The 2 x 4 studs must be located as sho_]] im] the chart,
Dh//. A. to accept moHmlt]mlg screws.
"A" "B"
Centerliee to Stud Hood Width
and Keyhome Slots At the Top
ZV48T 19-9/1 if' 40"
ZV48S 23-9/1ff' 47-15/16"
ZV36T 13-9/1ff' 28"
ZV36S 17-9/1ff' 35-15/W'
ZV30T 10-9/1 if' 22"
ZV30S 14-9/1ff' 29-15/W'
7-1/2"
Back of Hood
• [)]'ill l/8" pilot holes intotl/esmdsattl/elocathms
sho_m] im] the top _ie_ illustration.
mMPORTANT: Soffit framing must be capabme
of supporting up to 150 mbs.
mnstamm Transition Onto Top of Hood
IN PO£TANT: Remove
s!-fipping tape from
damper and check that
damper moves freely,
Duct
Transition
• Place the O'ansition piece over the hood exhaust mid
secure _ ]th 4 scre_ s provided.
Use d_ct tape to seal the com]ect]oi]. C]/eck to be sm'e
the damper m ores f}'ee]v.
Mount Hood onto Soffit or Cabinet
Note: }[[ mom]ti_]g to the u_]de]'side of a cabi]let ",_it]/ a
Engage Top
KeyholeSlots 1/4" Gap
PushBack_1_
to Wall
i
i
Add Shims
I If Bottom
l ls Recessed
Drive mom]ti_]g scre_sinto the studs m]ti] thev
protrude 1/4". The 1/4" gap _111 provide c]earance to
e_]gage the kev]]o]e slots
hi the
top of the hood_
i,ift hood to insta]]atio_] positiou. Locate h<mse _]rh]g
mldro_te thro_gh thek]]ocko_t ({}'ore the back or
top of the hood).
* I,]ft hood onto mom/ting scre_s. S]]de back agah]st
the rear _ a]].
*
Tigh
tell 0/O _1_1 [i _1 g sere'v, s.
][MPORT_T: For additional support and to mini-
mize %bration during operation, the hood must be
secured to the back wall, Use wall anchors to fasten
bottom back of bood to the wall.
12