Table of Contents
Advertisement
Installation
instructions
STEP 9 POSITION
DISHWASHER
UNDER
COUNTERTOP
• Push the dishwasher into the cabinet
° Push the sides with gour hands Do not use gour knee against
the door since door damage will occur.
° Check that the tub insulation blanket does not get
'bunched*up"
or interfere with the springs as gou slide it
into the cabinet
- Center the dishwasher
in the opening
, Front of door panel shouId be flush with face of cabinet
• Carefully open and close the door to ensure that the door
panel does not catch or rub on the cabinet frame
• tf the door catches or rubs on the frame, reposition and/or
level the unit Isee Step iO} until the door moves freelg and
does not contact the cabinet frame
The controls on these models are designed to be hidden bg
gour countertop
Align the dishwasher as shown in Figure
O Leave a 1/2" minimum
gap between the underside of the
countertop
and the top of the dishwasher door as shown in
Figure T,
Note: If the drain hose gets trapped behind the unit it can
prevent the controls from being hidden bg the countertop
Note: If this dishwasher is replacing an existing dishwasher, the
old countertop
bracket screw holes mog not be in the correct
position to accept a top-control
model New holes mag be
required.
Tip: The leveling tegs can be used to increase or decrease
the amount of gap between the controls and the countertop
affecting the visibiiitg of tile controls
IMPORTANT- Leave at/2"minimum
gap between
the controls
and the underside of the countertop
to prevent
condensation
and damage to the control panel from
screwheads.
_g P_rS_t_ pnngD i_ho_!h Qsher
With Hands
F
Do Not Push Against_
Front Door Panel With\..
Knee Damage
raThe
_,
Door Panel Will Occur,
Figure P
Door
Fits and
Swings
Back
Behind
Cabinet
Frame "
\
Door
catches
on Cabinet
Frame
/
Correct
Alignment
Figure 0
/
Incorrect
/
"-_.._ment
Top View
I
I
I'
I
I
I
Controls Hidden
bg Countertop
Figure R
Countertop
I
Dishwasher
Door
8
Figure S
Figure T
Advertisement
Table of Contents
