GE PDWT380R10SS Installation Instructions Manual page 6

Installation Preparation-Hot Water Supply
PREPARE HOT WATER SUPPLY
Hot Water Line
• The line meg enter from either side, rear or floor within the
shaded area shown in Figure F.
• The line meg pass through the same hole as the electrical
cable and drain hose, or an additional 1-!/2" diameter hole
meg be cut to accommodate the water line. If a power cord
with plug is used, the water line must not pass through the
power cord hole.
/
/ I
I
I
_1-1/2" Oi,
Hole
i i Shut-off 7
Valve Y
Hot_ i:::::::::: ,%.:',::',:':
P.
:: L.
_2"
From
Cabinet
CabinetFace_,-
I__.!9" From Wall
2" From Floor
=_
I \
\
I \
I \
I \
Figure F
CAUTION
The hot water supplg line pressure must be at least 20 PSI.
Lower pressures could cause the water valve to leak and
cause water
damage.
PRECAUCI6N
La linea de presi6n del suministro de ague caliente debe
ser al menos 20 PSI. Presiones inferiores podrian causer
que la v61vula del ague gotee g causer da_os por ague.
Water Line Connection
• Turn offthe water supplg.
• Install a hand shut-off valve in an accessible location, such
as under the sink. (Optional, but stronglg recommended
and meg be required bg local codes.)
• The water connection is on the bottom-left side of the
dishwasher. Install the hot water inlet line, using 3/8"
or larger copper tubing. Route the line as shown in Figure F
and extend forward at least 19" from rear wall.
• Adjust the water heater to deliver water between 120°F
and !50°F.
• Flush water line to clean out debris. Use a bucket to catch
water and debris.
• The hot water supplg line pressure must be between 20
and 120 PSI.