GE GDT550HGD0BB Installation Instructions Manual page 11

Dishwasher Installation
STEP 17: CONNECT DRAIN LINE (Cont.)
• Connect drain line to air gap, waste tee or disposer
using the previously determined method. Secure hose
with a screw-type clamp.
Method 1 - Air gap with waste tee or disposer
Waste Tee Installation Disposer Installation
Figure Y
Method 2 - "High drain loop" with waste tee or disposer
With this method you will need the drain hose hanger set aside
in Step 1.
Fasten drain hose to underside of countertop with the provided
hanger.
_ _ Drain Ho_,e o
Hanger
I r
32"
Waste Tee Installation
Figure Z
DisposerInstallation
IMPORTANT
- When connecting drain line to
disposer, check to be sure that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF PLUGIS LEFTIN PLACE.
4 Remove
Drain
Plug
Tip: Avoid unnecessary service call charges for a no drain
complaint.
Hake sure excess drain hose has been pulled through
the cabinet opening. This will prevent excess hose in the
dishwasher cavity from becoming kinked or crushed by the
dishwasher.
STEP 18: CONNECT POWER SUPPLY
If a power cord with plug is already installed proceed to
Step 19.
kWARNING:
If housewiring isnot 2-wire with ground,a ground must be
providedby the installer.When housewiring is aluminum,be sure
to useUL-Listedanti-oxidant compound and aluminum-to-copper
connectors.
A ADVERTENCIA:
Siel cableadodom@stico n o cuentacon un cablede 2 hiloscon
conexi6na tierra,un instaladordeberealizarunaconexi6na tierra.
Cuandoel cableadodom@stico e sde aluminio,aseg0rese de usar
un compuestoantioxidantey conectoresde aluminioa cobre
aprobadospar UL
In this step you will need the junction box cover and the
#10 Hex head screw from the screws set aside in Step 1.
• Secure house wiring to the back of the junction box with a
strain relief.
• Locate the 3 dishwasher wires, (white, black and green) with
the stripped ends coming out of the ACjumper. Use UL listed
wire nuts of appropriate size to connect incoming ground to
green, white to white and black to black.
• Install the junction box cover using #10 hex head screw.
Check to be sure that wires are not pinched under the cover.
• Make sure that the junction box cover is resting on the
mounting bracket.
NOTE:Do not remove the
Junction Box Bracket.
Ground
White
AC
Ground
Screw
Figure AA
Black
"_'_-_ Junction Box
Bracket
11