GE GDT550HGD0BB Installation Instructions Manual page 7

Dishwasher Installation
STEP 6: INSTALL 90 ° ELBOW
• Wrap a 90 ° elbow with
thread seal tape.
• Thread 90 ° elbow
Water Valve
onto the water valve.
Bracket
• Do not overtighten
elbow. Water valve
bracket could
bend or water valve
fitting could break.
Thread.
• Position the end of Seal
the elbow to face the Tape
rear of the dishwasher.
Figure K
Front of Dishwasher
_90 ° Elbow
Fill Hose
STEP 7: INSTALL DRAIN HOSE TO DRAIN
LOOP
Connect drain loop end to drain hose using the screw clamp
as shown in the figure.
Figure L
STEP 8: POSITION WATER LINE
AND HOUSE WIRING
• Position water supply line and house wiring on the floor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Line Wiring
Figure M
STEP 9: INSTALL DRAIN HOSE,
THROUGH CABINET
• Position dishwasher in front of cabinet opening. Insert drain
hose into the hole in cabinet side. If a power cord is used,
guide the end through a separate hole.
Maximum Drain Hose
Length 10'
In_
Blanket
Hose
/
House
Wiring
Power Cord
(If Used)
Figure N
Tip: Prevent unnecessary service call charges for fill, drain or
noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.