Mount The Microwave Oven - Hotpoint RVM1535MM1SA Installation Insrtuctions

Installation Instructions
MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTAI,IATION AND PERSONAI,
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
NOTE: If vour cabinet is metal, use tile nylon
grolmnet around tile power cord hole to prevent
cutting of tile cord.
NOTE: We recommend
using
filler blocks if tile
cabinet fl'ont hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are
not used, ease damage may occur from
overtightening screws.
NOTE: When motmting
tile
illicFowa;'e oven,
thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1-3. Do
not pinch cord or lift
oven by pulling cord.
[]I,ifl microwave, tilt
it forward and hook
slots at back bottom
edge
onto t()/li"
lower
tabs of motmting
plate.
_ Rotate front of
o_en
up against cabinet
bottom.
_lnsert a selt:aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
fight, Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet,
CabinetFront
CabinetBottomShelf
FillerBlock
T quivalent
to Depth
of Cabinet
Recess
Self-AligningScrew
MicrowaveOvenTop
[] Insert 2 selt:aligning screws
through outer top
cabinet
holes. Ttu'n two flfll ttli'ns
on
each
screw,
I
_ Tighten center
screw completely.
[] Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
tile top cabinet.)
/,
_ Install grease filter. See tile Owner's Manual
packed with the microwaxe.
18