Determining _All Plate L.oration - Hotpoint RVM1535MM1SA Installation Insrtuctions

Installation Instructions
DETERMINING WALL PLATE LOCATION UNDER YOUR CABINET
Template beneath cabinet
with flat bottom
Template beneath cabinet
with recessed bottom
Trimthe rearwall
template along
the dotted line.
II
I)raw a verticalline on the wall at
the centerof the 30" to 36" wide
space.Tapethe RearWall Template
onto the wall matching the
centerline andtouchingthe bottom
of the cabinet.
Template aligned with front overhang
on cabinet bottom
Drawa line on the
backwall equalto the
depthof the front
overhang. T rimthe
rearwall template
alongthe dotted line.
Trimthe rearwall ...........
templatealong
the dotted line.
Drawa vertical line on the wall at
the centerof the 30" or 36" space.
Tapethe RearWall Templateonto
the wall matchingthe centerlineand
touchingthe bottomcabinetframe.
I
THE MICROWAVE MUST BE LEVEL. [
I
Use a lexel to make sure the cabinet
bottom is lexel.
Your cabinets may have decorative trim that interieres
with the microwave installation, Remove the decorative
trim to install the microwave i)roperly and to make it
level,
On cabinets with a fl'ont overhang, draw a line on the
back wall at the same depth as the overhang. _Mign the
template to match overhang depth. This will kee I) the
microwave level.
[]Measure the inside depth of the fl'ont overhang.
[]Draw a horizontal line on the back wall to match
the depth of the fl'ont ovefl_ang. See illustration.
[]Draw a vertical line on the wall at the center of the
30" to 36" space. Trim the template on the dotted line.
Tape the Rear X4]_ll Template to the wall using the
marked centefline and top line as a guide.
9