Table of Contents
Advertisement
English
3
First start
At each power on, the instrument will first show all segments lit up,
then the ID number and software version [VER]. Number 8 is the
fixed ID when the Compass transducer is connected direct at the
instrument and the setting in C71 is on (default setting).
3.1
Initialising the instrument in a Nexus Network
At the first power on after installation, you will be asked to press SET
[PrSKEY]. This will give the instrument a logical ID number from 16
and upwards on the Nexus Network.
To initialise the instrument, press SET, one at a time, on all installed
digital instruments,.
Note: Always wait for the text "Init OK"
to be displayed, before you press SET
on the next instrument!
The Server automatically gives the first unit ID number 16, then 17
and so on. The order in which you press SET, will be the same order
as the instruments will be addressed by the Remote Control, if used.
The example shows that the instrument version number is 1.00 and
the given logical ID number is 16. The ID number will always be 8 if
the Compass transducer is connected to this instrument. If the
instrument is a repeater, it may have any number from 16 and up.
3.2
Re-initialising the instrument
If and when two instruments by mistake have the same ID number,
you must re-initialise the instruments to avoid network disturbance
and blockage of data.
To re-initialise the instrument, press MINUS and PLUS together
during the power up sequence, i.e. when version and ID numbers
are displayed.
The display test is then re-started on all instruments and you will be
asked to press SET (ANY KEY) on each instrument as explained
above.
Note! If you do not succeed to re-initialise, we suggest you
disconnect (just pull out the connection plug) all, except one of the
instruments that had the same ID number, then repeat the above
procedure. Reinstall the instruments and redo the "PRESKEY"
procedure.
5-12
COMPASS
Advertisement
Table of Contents
