Place the assembMed strain relief
plate
back into the iuncfion
box and re-attach
the screw.
Make
sure the tab on the right
side of the strain relief
plate
is outside the iuncfion box as
you slide it into place.
Note: Do not loosen or remove terminal
screws!
Damage
may occur. Bend the wires so the exposed
leads can reach
the appropriate
contacts, insert the black (hot) wire into
the left opening
on the terminal
strip marked
"L', the white
(neutral)
wire in the middle
opening
of the terminal
strip
marked
"N', and the bare copper
or green
(ground)
wire
into the right opening
of the terminal
strip marked
"G'.
©
14