Kenmore 630.1390 Installation Manual page 10

STEP6
Attaching the hot water ilne
NOTE: The 90 ° elbow fitting is not supplied with the
dishwasher and must be purchased separately (see
"Materials Needed" section).
STEP 1
To prevent leaks, wrap the dishwasher elbow with plumbing
tape firmly in a clockwise direction twice. Inspect the elbow
carefully for any breaks before you attach it to the water
supply line
STEP 2
To attach the elbow to the dishwasher, align the elbow
with the water supply opening of your dishwasher. To lock
the elbow in place, twist the elbow clockwise and tighten
until snug. When tightening the elbow, make sure that the
opening of the elbow ends up facing backwards. Use an
adjustable wrench to tighten. DO NOT overtightenJ
Attach hot water line to 90 ° elbow and route water line
underneath machine toward hot water connection.
Regardless of where the electrical supply cable originates,
position it 21" (54 cm) from the opening's left side. Extend
the cable 30" (77 cm) from the back wall.
Use tools recommended by the hot line manufacturer.
10