How To Connect For Bi-Amp - McIntosh MC601 Owner's Manual

Quad balanced power amplifier

Hide thumbs Also See for MC601:

Connection diagram (2 pages)

Owner's manual (20 pages)

Table Of Contents

Table of Contents

8. Attach the previously prepared bare wire cable ends

into the banana plugs and secure the

connections. Refer to figure A.

9. Refering to Figure B, connect the

Loudspeaker hookup cables with

banana plugs into the hole

at the top of the terminal

to the MC601 Negative

Output Terminal and

Positive Output Terminal

impedance of the Loudspeaker, being careful to

observe the correct polarities.

Note: The illustration in Figure 5 is connections for

If the Loudspeaker's impedance is in-between the

available connections, use the nearest lower imped-

ance connection. Refer to "General Information"

Note 4 on page 3 for additional information.

WARNING: Loudspeaker terminals are hazard-

ous live and present a risk of electric

shock. For additional instruction on

making Loudspeaker Connections con-

tact your McIntosh Dealer or McIn-

tosh Technical Support.

10. Attach the Terminal Connections Cover to the

MC601 Rear Panel with the previously removed

Screws. Refer to figure 5.

11. Connect the MC601 power cord to an active AC

outlet.

12. Locate the Terminal Connections Cover from the

inside of the MC601 shipping carton. Insert the

just prepared Loudspeaker hookup cables thru the

cover openings. Refer to figure 6.

!"#$%&'(

Cover Openings

!"#$%&'(

13. Connect the Loudspeaker hookup cables to the

MC601 Negative Output Terminal and Positive

impedance of the Loudspeaker, being careful to

observe the correct polarities. Insert the spade

lug connector or prepared section of the cable end

into the terminal side access hole, and tighten the

terminal cap until the cable is firmly clamped into

the terminals so the lugs or wire cannot slip out.

Refer to Figures 7 and 8.

Cover Screws

!"#$%&'(

!"#$%&')