How To Connect - McIntosh MC601 Owner's Manual

Cover Openings
Cover Screws
If the Loudspeaker's impedance is in-between
the available connections, use the nearest lower
impedance connection. Refer to "General Informa-
tion" Note 4 on page 3 for additional information.
WARNING: Loudspeaker terminals are hazard-
ous live and present a risk of electric
shock. For additional instruction on
making Loudspeaker Connections con-
tact your McIntosh Dealer or McIn-
tosh Technical Support.
8. Attach the Terminal Connections Cover to the
MC601 Rear Panel with the previously removed
Screws. Refer to figure 5.
9. Connect the MC601 power cord to an active AC
outlet.
10. Locate the Terminal Connections Cover from the
inside of the MC601 shipping carton. Insert the
just prepared Loudspeaker hookup cables thru the
cover openings. Refer to figure 6.
Cover Openings
Cover Screws
11. Connect the Loudspeaker hookup cables to the
MC601 Negative Output Terminal and Positive
impedance of the Loudspeaker, being careful to
observe the correct polarities. Insert the spade
lug connector or prepared section of the cable end
into the terminal side access hole, and tighten the
terminal cap until the cable is firmly clamped into
the terminals so the lugs or wire cannot slip out.
Refer to Figures 7 and 8.
!"#$%&'(
Note: The illustration in Figure 6 is connections for
If the Loudspeaker's impedance is in-between
the available connections, use the nearest lower
impedance connection. Refer to "General Informa-
tion" Note 4 on page 3 for additional information.
WARNING: Loudspeaker terminals are hazard-
12. Attach the Terminal Connections Cover to the
MC601 Rear Panel with the previously removed
Screws. Refer to figure 6.
13. Connect the MC601 power cord to an active AC
outlet.
!"#$%&')

How to Connect

ous live and present a risk of electric
shock. For additional instruction on
making Loudspeaker Connections con-
tact your McIntosh Dealer or McIn-
tosh Technical Support.
9