Dehumidifying Operation; Adjusting Airflow Direction; Timer Operation (Timer On/Timer Off/Dual Timer) - Midea CR034-RG36F Remote Control Manual

Dehumidifying Operation

Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the
desired temperature. The temperature
can be set within a range of 17 C ~ 30 C
O
in 1 C increments.
3
3. Press the ON/OFF button to start the air
2 ON/OFF 2
conditioner.
TEMP
NOTE
1
In the Dehumidifying mode, you can not switch the fan
MODE SILENCE
FP
speed. It has already been automatically controlled.
FAN
SPEED
SWING

Adjusting Airflow Direction

TIMER
SWING ON/OFF
Use the SWING
the desired airflow direction.
SLEEP
INTELLIGENT
FRESH
EYE
1. When the SWING
TURBO LED horizontal louver changes 6 degrees in angle for
SELF FOLLOW
CLEAN
ME
each press. If pressed for more than 2 seconds,
the louver will automatically swing up and down.
RESET
LOCK
2. When the SWING
vertical louver changes 6 degrees in angle for
each press. If pressed for more than 2 seconds,
the louver will automatically swing left and right.
NOTE
When the horizontal/vertical louver swings or moves
to a position which would affect the cooling or
heating effect of the air conditioner, it would
automatically change the swing/moving direction.
O O
and SWING buttons to adjust
button is pressed, the
button is pressed, the
9
Timer Operation
Press the TIMER ON button to set the Auto-On
time of the unit. Press the TIMER OFF button
to set the Auto-Off time of the unit.
To set the Auto-On time
1. Press the TIMER ON/OFF button to show
'TIMER ON' on the display. The last Auto-On
setting time and the signal 'H' will be shown on
the LCD display area. Now it is ready to reset
2
2
ON/OFF
the Auto-On time to START the operation.
TEMP
2. Push the +/- buttons to set desired Auto-On
time. Each time you press the button, the time
MODE SILENCE
increases by half an hour between 0 and 10
FP
hours and by one hour between 10 and 24 hours.
FAN
SPEED
3. After setting the TIMER ON, there will be a one
SWING
second delay before the remote control
TIMER
1
transmits the signal to the air conditioner. Then,
SWING ON/OFF
after approximately another 2 seconds, the
SLEEP
INTELLIGENT
signal 'H' and time will disappear and 'TIMER
FRESH EYE
ON' indicator will remain on the LCD display
TURBO
LED
SELF FOLLOW
window. The set temperature will re-appear on
CLEAN ME
the LCD display window.
LOCK RESET
To set the Auto-Off time
1. Press the TIMER ON/OFF button to show
'TIMER OFF' on the display. The last Auto-Off
setting time and the signal 'H' will be shown on
the LCD display area. Now it is ready to reset
the Auto-off time to STOP the operation.
2. Push the +/- buttons to set desired Auto-Off
time. Each time you press the button, the time
increases by half an hour between 0 and 10
hours and by one hour between 10 and 24 hours.
3. After setting the TIMER OFF, there will be a
one second delay before the remote control
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal 'H' will disappear and 'TIMER OFF'
indicator will remain on the LCD display window.
The set temperature will re-appear on the LCD
display window.
10