Install The Stand; Install The Stand To The Pdp - Haier 42EP24STV Owner's Manual

Install the Stand

Install the PMMA Baffle
After installing the brace pole(see figure below)
rip the protective sheet off of the PMMA
and put the baffle into the stand.
Install the brace pole
1 After put the brace pole to the stand,
use the screw 8 M4x12 to fix it.
2 Take care not to touch the stand and
the brace pole;
3 Fix the PMMA baffle with the
screw 2 M4X8rom the front .

Install the Stand to the PDP

Face the PDP screen upside down on a clean blanket or the bracket and pay attention not to indent the casing. (See figure)
Lay down the stand and put it to responding position of the PDP screen ,and make sure the brace pole towards the hole of the PDP .
Fix 2 PDP brace pole to the PDP on the back of the plasma display with 4 M5X16 screws.
baffle
Owner s Manual 15