Vcr Setup; Cable Tv Setup - Haier 42EP24STV Owner's Manual

- To avoid picture noise (interference), leave an adequate distance between the VCR and TV
Do not leave a still picture from a VCR on the screen for a long If the 4:3 format is used, the fixed images on the
sides of the screen may remain visible on the screen, if this format is used day after day. This is known as burn-in, it
is uneven wear of the screen area. Reduce contrast when displaying fixed images on the screen for a long
1.
Connect the audio and video cables from the
VCR's output jacks to the
as shown in the figure.
When connecting the TV
the jack colors (Video = yellow, Audio Left = white,
and Audio Right = red).
If you connect an S-VIDEO output from VCR to
the S-VIDEO input, the picture quality is
improved; compared to connecting a regular
VCR to the Video input.
2.
Insert a video tape into the VCR and press
PLAY on the VCR. (Refer to the VCR owner`s
manual.)
3
. Select the input source by the INPUT button
on the remote control.
Do not connect to both Video and
S-Video at the same In the
event that you connect both Video
and the S-Video cables, only the
S-Video will work. So you should
not connect to S-Video if you want
to use Video.
- After subscribing to a cable TV service from a local provider you can watch cable TV programming. The
display TV programming unless a TV tuner device or cable TV converter box is connected to the
- For further information regarding cable TV service, contact your local cable TV service provider(s).
1
. Connect the co-axial cable from antenna out of the cable box to
antenna in of the TV.
2
. Connect the audio and video cables from the Cable Box's output
jacks to the TV`s AV IN input jacks, as shown in the figure.
When connecting the TV to a Cable Box, match the jack colors
(Video = yellow, Audio Left = white, and Audio Right = red).
(If you have a digital cable box please refer to page 12 , for DTV setup)
3
. Select the input source by using the INPUT button on the
remote control. (If connected to AV IN, select AV1/S-VIDEO input source)
4.
Select your desired channel with the remote control for cable box.
10 Plasma TV
TV input jacks,
to VCR, match
ANT IN
TV cannot
TV .
ANT IN
(Co-axial)