4.
Add strain relief.
Style 1: Power supply cord strain relief
•
Assemble a UL listed strain relief in the opening.
A
A. UL listed strain relief
•
Feed the power supply cord through the opening in the
cord/conduit
plate on bottom of range. Allow enough
slack to easily attach the wiring to the terminal block.
•
Tighten strain relief screw against the power supply cord.
Style 2: Direct wire strain relief
•
Use Phillips screwdriver to remove screws from panel on
back of range.
•
Lift range back panel up and off.
Use Phillips screwdriver to remove screws and slide
cord/conduit
plate down and out.
•
Position cord/conduit
plate as shown in the following
illustration.
•
Replace cord/conduit
plate and insert screws.