Advertisement
Available languages
Available languages
INSTALLATIONINSTRUCTIONS
30" (76.2 CM) ELECTRIC SINGLEAND DOUBLE
BUILT-INOVEN
INSTRUCTIONSD'INSTALLATION
FOURELECTRIQUE ENCASTRE 30" (76,2 CM) -
SIMPLE ETDOUBLE
Table of Contents / Table des mati_res
BUILT-IN OVEN SAFETY .................................
1
.................. 2
Tools and Parts .............................................
2
Location Requirements .................................
2
................................ 4
.................... 4
Prepare Built-In Oven ....................................
4
Remove Oven Trim .......................................
4
Make Electrical Connection ..........................
5
Install Oven ....................................................
7
Complete Installation ....................................
8
SI_CURITI_ DU FOUR ENCASTRI_ .................. 9
..................... 10
Outillage et pieces .......................................
10
Exigences d'emplacement
.......................... 10
electriq ues ............................ 12
............... 12
Preparation du four encastre ....................... 12
D_pose des garnitures du four .................... 13
electrique ............................ 13
Installation du four .......................................
15
Achever I'installation .................................... 16
BUILT-INOVEN SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
You can be killed or seriously injured if you don't immediately
follow
instructions.
You can be killed or seriously injured if you don't follow
instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
iMPORTANT:
Save for local electrical inspector's use.
iMPORTANT
:
,&,conserver pour consultation par I'inspecteur local des installations 61ectriques.
8303102A
Advertisement
Table of Contents
Related Manuals for IKEA IBD550PRS02
Summary of Contents for IKEA IBD550PRS02
-
Page 1: Table Of Contents
INSTALLATIONINSTRUCTIONS 30" (76.2 CM) ELECTRIC SINGLEAND DOUBLE BUILT-INOVEN INSTRUCTIONSD'INSTALLATION FOURELECTRIQUE ENCASTRE 30" (76,2 CM) - SIMPLE ETDOUBLE Table of Contents / Table des mati_res BUILT-IN OVEN SAFETY ......... SI_CURITI_ DU FOUR ENCASTRI_ ....9 INSTALLATION REQUIREMENTS ....2 EXIGENCES D'INSTALLATION ..... -
Page 2: Installationrequirements
INSTALLATIONREQUIREMENTS Product Dimensions - Single Oven Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed • Phillips screwdriver • Measuring tape • Hand or electric drill (for wall cabinet installations) •... - Page 3 Single Oven Installed in Cabinet Cabinet Dimensions - Double Oven Double Oven Installed in Cabinet A. 30" (76.2 cm) min. cabinet width B. 1" (2.5 cm) top of cutout to bottom of upper cabinet door A. 30" (76.2 cm) min. cabinet width C.
-
Page 4: Installationinstructions
• If the house has aluminum wiring follow the procedure below: 1. Connect a section of solid copper wire to the pigtail leads. Ifcodes permit and a separate ground w ire isused, i tis recommended thataqualified electrical installer determine that 2. -
Page 5: Make Electrical Connection
Grasp the edges of the oven door with both hands and close the oven door until it will no longer close. Lift and pull oven door toward you and remove. Set the oven door aside on a covered work surface. Electrical Shock Hazard Disconnect power before servicing. - Page 6 4-Wire Cable from Home Power Supply 3-Wire Cable from Home Power Supply - U.S. Only IMPORTANT: Use the 4-wire cable from home power supply in IMPORTANT: Use the 3-wire cable from home power supply the U.S. where local codes do not allow grounding through where local codes permit a 3-wire connection.
- Page 7 ..Securely fasten oven to cabinet using the #8-14 x 1" screws (2 for single oven, 4 for double oven) provided. Insert the screws through holes in mounting rails. Do not overtighten screws. Excessive Weight Hazard Use two or more people to move and install oven. Failure to do so can result in back or other injury.
-
Page 8: Checking Operation Of Oven
7. Slide top end of each trim piece upward onto oven side rails. 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. ,_¢_<... - Page 9 SECURITE DU FOUR ENCASTRE Votre securite et celle des autres est tres importante. Nous donnons de nombreux messages de s_curit_ importants dans ce manuel et sur votre appareil m_nager. Assurez-vous toujours lire tousles messages de s_curit_ et de vous y conformer. Ce symbole d'alerte de s_curit_ vous signale les dangers potentiels de d_c_s et de blessures graves &...
-
Page 10: Exigences D'installation
EXIGENCES D'INSTALLATION La surface de support du four doit _tre robuste, horizontale et en affleurement avec le bas de I'ouverture decoupee dans le placard. Le plancher doit pouvoir soutenir le poids du four : Rassembler les outils et pieces necessaires avant de commencer 140 Ib (63,5 kg) pour un four simple, ou 245 Ib (111,1 kg) pour I'installation. - Page 11 Four simple install_ dans un placard Dimensions du placard - Four double Four double install_ dans un placard A. Largeur du placard 30" (76,2 cm) min. B. 1" (2,5 cm) du sommet de I'ouverture au fond de la porte du placard sup_rieur A.
-
Page 12: Instructions D'installation
• Le c&ble blinde flexible du four dolt _tre connecte directement dans le boitier de connexion. • Installer un fusible pour chaque fil de phase. Si on utilise un conducteur distinct de liaison a la terre Iorsque les codes le permettent, il est recommande qu'un electricien qualifie •... -
Page 13: Raccordement Electrique
Faire glisser I'extremit6 superieure de la tringle de garniture vers le bas pour pouvoir separer la tringle du four. Conserver Depos® des gcsm i ®s la tringle a part. IMPORTANT : Employer les deux mains pour enlever la porte du four. - Page 14 Tableau des options de raccordement _lectrique C&ble & 3 cpnducteurs depuis le point de distribution du Voir la section : C&blage de la maison : domicile - E.-U. seulement 4 conducteurs C&ble & 4 conducteurs depuis IMPORTANT : Utiliser le c&ble & 3 conducteurs depuis le point de le point de distribution du distribution du domicile Iorsque les codes Iocaux autorisent un tel...
- Page 15 Fixer solidement le four sur les el6ments du placard avec les vis n° 8-14 x 1" fournies (2 pour un four simple, 4 pour un four double). Inserer les vis & travers les trous des rails de montage. Ne pas serrer excessivement les vis.
- Page 16 8. Appuyer pour inserer chaque piece de garniture et la mettre en place a I'extremit6 inferieure. 1. Verifier que toutes les pieces sont maintenant installees. 8II reste une piece, passer en revue les differentes etapes pour decouvrir laquelle aurait ete oubliee. 2.