Advertisement
Available languages
Available languages
Check that leveling legs are firmly against the floor. Close and
latch the door, and place level against the front panel. Check that
dishwasher is centered from front to back in the opening. If
needed, adjust leveling leg until dishwasher is plumb. Repeat for
other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it may
be easier to adjust the front leg using the ¾6" hex head socket or
adjustable wrench.
Place level against top front opening of tub. Check that
dishwasher is level from side-to-side.
If dishwasher
is not level,
adjust front legs up or down until dishwasher is level.
_ii_
_i_ _'P_/y_ _
_
_ _
_'_" ,_,
,
_t_ _'_}
_,_+
_ _,<
_;@>_ _+
>
_
_,+)
,t
_
_ _ _
_
b _
Be sure rubber washer is properly seated in fitting. Slide the 3/4"
fitting up to the valve and hand tighten to avoid cross-threading.
Hand tighten until the coupling is tight.
Using pliers, check the tightness of the coupling. An additional
V4to V2turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
Place paper towel under 90 ° elbow fitting. Turn on water supply
and check for leaks. If leak occurs, repeat previous step.
If needed, see website for animated representation
of this step.
Visit www.jenn-air.com/watersupply
under FAQ tab.
NOTE: Do not use Teflon ®ttape with compression fittings.
1-®TEFLON is a registered trademark
of E.I. Du Pont De Nemours and Company.
21
Advertisement
