Advertisement
Available languages
Available languages
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Using 2 or more people, stand the dishwasher up.
NOTE: Do not install kick plate until instructed to do so.
1_ Custom
panel
installation
=':J Dishwashers
with control
|
p a n e I o n t h e t o p
.....
;cm)
%" (19.1 mm)
*This dimension
is for 4" (10.2 cm) toe kick. If the
installation
needs a higher toe kick, adjust the height
of the wood panel accordingly.
Not recommended
for
toe kicks greater than 6" (15.2 cm).
J
Attach
handle
Install the custom hardware handle(s) on the front of the wooden
panel inside dotted line.
IMPORTANT: If the handle is attached from the back of the
custom panel, the screw holes should be countersunk
for the
screws heads to be flush with the panel. If the handle is attached
to the front of the custom panel, the screw lengths cannot exceed
the panel thickness.
Topof Panel
T_padelpanel
Dessusdupanneau
Centerline
Linea
central
Axe central
Using the template provided, attach it to the backside of the
custom panel with tape. Make sure that the center of the template
is aligned with the center of the wooden panel and top of the
template is aligned to the top face of the wooden panel.
NOTE: Do not drill deeper then %" (16 mm) to keep from drilling
through panel. Pilot hole depths given are for 3/4"(19 mm) thick
panel.
Mark 4 pilot holes on the wooden panel using the template
provided. Predrill 4 pilot holes using a 3_32" d rill bit. Use tape to
mark the drill bit to gauge hole depth. Drill pilot holes
approximately 5/8"(16 mm) into the custom panel.
16
Advertisement
