Jenn-Air JDB8000AWB1 Installation Instructions Manual page 22

Connect drain hose
Small clamp --
Black drain hose
Drain hose
Drain hose stop
Stop
Place towel under drain hose to catch any water in drain hose.
Place the small drain hose clamp onto the small end of the drain
hose. Push the new drain hose into the black drain hose
connector up to the drain hose stop.
Using pliers, squeeze open the small drain hose clamp and slide
onto connector between stops.
3 !
Hose clamp final position
Drain hose
Black drain hose
connector
Drain hose stop
Stop
After hose is connected, remove towel.
If needed, see website for animated representation of this step.
Visit www.jenn-air.com/drain under FAQ tab.
NOTE: If the power supply cord was connected earlier, proceed to
"Secure Dishwasher in Cabinet Opening" section.
Option B, Direct Wire:
Route cable so that it does not touch dishwasher motor or lower
part of dishwasher tub. Pull cable through UL Listed/CSA
Approved strain relief in terminal box. Strain relief is not supplied
with the dishwasher. Owner must purchase a 7/8"screw-in type
strain relief.
Select UL Listed/CSA Approved twist-on wire connectors (not
included) rated to connect your household wiring to 16-gauge
dishwasher wiring.
22