Download Print this page

Jenn-Air JDB8000AWB1 Installation Instructions Manual page 11

Undercounter dishwasher
Hide thumbs Also See for JDB8000AWB1:

Advertisement

Available languages

Available languages

Option D, No waste disposer - with air gap
1. Connect rubber end of drain hose to
air gap and cut if needed.
NOTE: Do not cut ribbed section.
2=
Attach drain hose to air gap with
large drain hose clamp (provided).
Use pliers to squeeze clamp open
and move into position. If the drain
hose was cut, use a 11/2 '' to 2" (3.8 to
5 cm) screw-type
clamp (not
provided).
3=
Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from waste tee
to air gap.
Install
moisture
barrier
i
............
(under
a wood
countertop)
Moisture
barrier
1=
2.
Make sure the area under the cabinet is clean and dry for
installation of the moisture barrier.
Remove the backing of the moisture barrier and apply to
underside of the countertop along the front edge of the
counter.
Tip Over Hazard
Do not use dishwasher
until completely installed.
Do not push down on open door.
Doing so can result in serious
injury or cuts.
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Helpful Tip: Place cardboard under dishwasher until installed in
cabinet opening to avoid damaging floor covering. Do not use
door panel as a worktable without first covering with a towel to
avoid scratching the door panel.
Using 2 or more people, grasp sides of dishwasher door frame
and place dishwasher on its back.
11

Advertisement

loading