Jenn-Air JDB8000AWB1 Installation Instructions Manual page 17

Visible side
Attach the 4 plastic studs to the wooden panel using the 4 short
hex head (5/lo")screws provided.
Attach custom tape
Check custom tape alignment with metal door slots; verify tape is
right-side up, and that the tape does not overhang the metal door
on the top, bottom or side interfaces. Remove the backing from
the custom tape by pulling straight down on the liner. Align the
custom tape to the keyhole slots on the metal door (see image)
and apply. Repeat steps for one side and then the other.
NOTE: The adhesive on the tape is aggressive, so proper
alignment and attachment to the metal door needs to occur on
the first try.
Attach custom
assembly
Align the studs on the custom wood panel to the keyhole slots on
the door assembly. Ensure that all 4 plastic studs are engaged in
the keyhole slots. Slide wood panel down until the top surface of
the wooden panel is flush with the top of the door.
Customer-supplied
panel
Drill through
these holes.
Remove 2 short screws
and replace with long
screws provided,
Open the door and align top edges. Predrill 2 pilot holes using a
3/32" d rill bit. Use tape to mark the drill bit to gauge hole depth. Drill
pilot holes approximately 11/2"(3.8 cm) into the top corners of the
door using hole in liner as a guide.
Customer-supplied
panel
top
edges
:)rill through
these holes
Install 2 long screws supplied in top corners to secure custom
wood panel in place.
17