Jenn-Air JDB8000AWB1 Installation Instructions Manual page 15

Euro handle
Pro-Style @
handle
Mountinc
stud
, Setscrew
i
(in bottom
of handle)
Hex key
Classic handle
_,_ Setscrew
(in bottom
Hex key of handle)
J
IMPORTANT: Do not scratch the front panel during this
procedure.
Remove the door handle and hardware bag containing the
setscrews and hex key from the cardboard box. Setscrews are
already installed in the handle. Place handle on mounting studs
with the setscrews facing down. Push the door handle tightly
against the door. Insert the short end of the hex key into the
setscrews. Tighten the setscrews 1/4 turn past snug.
Retain hex key with Installation Instructions.
with control panel on the top
235/8.._r--_ ,,
(60 cm) | *292%2 (76 cm)
3/4"(19.1 mm)
*This dimension is for 4" (10.2 cm) toe kick. fthe
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
Follow steps below:
A customer supplied panel must weigh no more than 16 Ibs
(7.3 kg) and must be made to specific dimensions. It is
recommended that a cabinetmaker cut the customer panel
because of the precise dimensions needed.
NOTES:
• The handle for the custom panel is not included.
All mounting hardware supplied is for a 3/4"(19.1 mm) thick
wood panel. If a thinner wood panel or materials other than
wood are used, it is the customer's responsibility to obtain the
proper length screws and adjust the pilot holes accordingly.
IMPORTANT: Use a moisture-resistant sealer on both sides and
all edges of the panel to avoid damage from moisture.
15