Insert; Main Section - Alto S-12 User Manual

4.15 INSERT

Insert points are provided for the Mono Mic Channels.
When you insert a jack in the insert socket, the signal
will be taken out after the Input Gain Control (Trim),
sent to an external processor such a compressor-
limiter, and returned into the channel strip immediately
before the EQ section. Of course, these jacks used must
be stereo (Tip Send/Ring Return).

4.16 MAIN SECTION

-. STEREO AUX RETURN
Use these stereo 1/4" phone socket to return the
sound of an effect unit or sound processor to the
Main Mix.
Alternatively you can use them as an extra auxiliary
input.
-. AUX SEND 1 & 2
This 1/4" phone socket is used to send out the
signal from the AUX Bus to external devices such
as effects and sound processors.
-. CONTROL ROOM OUTPUT
These two unbalanced TRS jacks should be connected to the input of your control room amplifier.
-. 2-TRACK IN / OUT
Input
Use the Tape input if you wish to listen to your Mix from a Taper Recorder or DAT, You can assign the signal coming
form the Taper Recorder either to a pair of studio monitor using the Control Room assignment on the front panel or
you can also send the signal directly to the Main Mix.
Output
These 1/4" TRS sockets will route the main mix into a tape recorder.
18
19
20
21
22
(P RE -FADER/PRE-EQ TIP SEND/RING RETURN)
CH4
19
STEREO AUX RETURN
LEFT(MONO) RIGHT
1
LEFT
RIGHT
2
11
CHANNEL INSERT
CH3 CH2 CH1
18
20 21 22
CTRL ROOM
AUX SEND 2-TRACK IN/OUT
OUTPUT
1
L L
R R
2
TAPE IN TAPE OUT