Table of Contents
Advertisement
STEP 6:
ATTACH THE OVEN TO THE WALL
6. Roof-vented installation: Align the damper/duct connector
with the vent on top of the microwave oven. Damper
should be on top of tab. Use two tapping screws(bright-
colored) to attach damper/duct
connector to the microwave
oven. See Figure 33.
NOTE: Damper/duct connector must be attached to
microwave oven after microwave oven is installed•
7. Roof venting installation: Install ductwork through the vent
opening in the upper cabinet• Complete the venting system
through the roof according to the method needed• See
Figure 34. See "PREPARE THE VENTING SYSTEM,"
STEP 2 on the page 8. Use caulking to seal exterior roof
opening around exhaust cap. See Figure 6 on page 8.
8. Use power supply cord clamp to bundle the power supply
cord. Install power supply cord clamp, using screw as
shown in Figure 34, to inside of the cabinet.
9. Grasp filter screen with one hand holding the ring and the
other hand holding the opposite end. Insert the end of the
filter screen without ring into the opening and slide towards
the side of the microwave oven. Insert ring end of filter
screen into the opening and slide entire screen towards the
center of the microwave until screen is securely in position•
Repeat for other filter screen• See Figure 35.
N"
/
///]
damper
Figure
33
!
I
............................
/"7
_
"
)
Figure 33 Detail
I1-:-1
%\HI ",power
i
I
I1©1
_,_VI supply
i
I
I _
;1 I cord
,[--I,
-'_:_---_-.
J clamp
Figure 34
10. Plug in the power supply cord.
11. Read your Owner's Manual, then check the operation of
your microwave oveR.
Figure 35
i16i
Hide quick links:
Advertisement
Table of Contents
