Kenmore 721.67600 Installation Instructions Manual page 15

STEP 6:
ATTACH THE OVEN TO THE
WARNING
You will need two people to lift this microwave.
Failure to use more than one person could result in
personal injury.
1. Carefully lift microwave oven and hang it on support tabs
(See Figure 26) at the bottom of the mounting plate.
Reaching through upper cabinet, thread power supply cord
through the power supply cord hole in the bottom of the
upper cabinet. See Figure 30.
2. Rotate microwave upward so that top of oven is against
bottom of upper cabinet or cabinet frame.
3. Drop the lock pin and washer assembly into hole "N" (left
side hole) and push pin down as far as it will go.
See Figure 31.
!
Figure 30
4. Place washers over two, 1/4"x3" bolts. Then insert a bolt
down through each hole in the upper cabinet bottom. Tighten
the bolts until the gap between the upper cabinet and
microwave oven is closed. See Figure 32.
5. Remove lock pin and washer.
If wall-vented or room-vented installation is used, go to No. 8
on the next page.
Figure 31
Figure 32
--15--