Operating Instructions; Control Panel; Control Panel Operation - L.A. Spas 2010 North American Owner's Manual

CONTROL PANEL

This easy to use control has been pre-programmed to be "plug and play". Turn the power on, adjust the
desired temperature and the system is ready to go. If there are situations that require additional filtering
time, the filter settings can be customized to any special requirements. Simple to use and easy to read,
the Control System makes using the spa effortless.

CONTROL PANEL OPERATION

Please note: The pump has an automatic timeout (shut-off) programmed 30 minutes after the pump is
activated. The low speed pump will remain running if there is a call for heat, and will continue to do so
until the set temperature is reached.
1. Jets key:
When the Jets key is pressed the first time, the low speed of the jet pump is turned on. When the
Jets key is pressed the second time, the high speed of the jet pump is turned on. Pressing the
Jets key the third time will turn the pump off.
2. Light key:
Press the Light key once to turn the light on. Press the Light key a second time to turn off the
light.
3. Temp key:
Press the Temp key once to display the set temperature. To change the set temperature, press
the Temp key a second time before the display stops flashing. Each press of the Temp key will
continue to either increase or decrease the set temperature. If the opposite direction is desired,
allow the display to revert to the water temperature. Press the Temp key to display the set
temperature, and again to make the temperature change in the desired direction. After three
seconds, the display will stop flashing and begin to display the current water temperature. The
default temperature is programmed at 100°F (38°C).

OPERATING INSTRUCTIONS

14