Kenmore 721.80002 Installation Instructions Manual page 15

STEP 5: INSTALL THE MOUNTING
PLATE TO THE WALL
THE OVEN MUST BE CONNECTED
TO AT LEAST ONE WALL STUD.
1, Draw a vertical line on the wa II at the center of the
30" wide space,
Use the mounting plate as the template for the
rear wall, Place the mounting plate on the wall,
making sure that the tabs are against the bottom
of the cabineL Line up the notch and center line
on the mounting plate to the center line on the
wall,
2, While holding the mounting plate with one hand,
draw circles on the wall at holes "A", "B", "C"
and "D". Four holes must be used for mounting, If
the holes are not used, the installation will not be
secure, Installer must use these holes for proper
installation, Use toggle bolts through these holes
unless one of them lines up with a stud, Use a
wood screw for studs, See Figure 26.
NOTE: Draw a fifth circle inside area "E", through
one of the holes to match the location of a
stud.
For wall vented: The oven requires a rear wall
cutout opening for the rear wall duct and the
exhaust adaptor must be attached to the mounting
plate. See the next page on how to prepare the rear
wall cutout opening and the exhaust
adaptor/mounting plate for wall vented.
3, Drill holes through the circles. If there is a stud,
drill a 3/16" hole for lag screws, Two or preferably
four lag screws at holes "A" and "C", or"B" and
"C" must be used to secure mounting plate to
wall, If there is no stud, drill a 3/4" hole for toggle
bolts. Make sure to use at least 1 lag screw at
holes of area "E" in a stud, and 4 toggle bolts at
holes "A", "B ", "C" and "D" in the drywa II or the
plaster,
4, Attach the plate to the wall, To use spring toggle
head bolts: Remove the toggle wings from the
bolts. Insert the bolts into the mounting plate and
replace the spring toggle heads to 3/4" past the
bolt ends, Insert the spring toggle heads into the
holes in the wall to mount the bracket. You may
pull forward on the bracket to help in tightening
the toggle bolts. Tighten all bolts. See Figure 27,
3/16Hole on S tuds
[_F_ _ 5/8Hole on Dry wall Only
Minimum 66"
Ill ILL 'y
/ s Draw Lines
j / Or] S_U(tS
_ [)raw
l L _ J t
SupportTab SupportTab
(3 pieces mounting plate)
Figure 26
_ Space More Tha
M°SS ,,,Togg,o Oo,,tlI",L
Figure 27
15