Kenmore 721.80002 Installation Instructions Manual page 10

STEP 3:
PREPARE THE VENTING BLOWER
Your microwave oven is shipped with the blower assembled for room venting (recirculating). You need to adjust
the blower if you want wall vented or roof vented installation.
WAR NING
ELECTRICAL SHOCK HAZARD! UNPLUG UNIT BEFORE WORKING .ON
DO NOT PULL OR STR ETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could result
in electrical shock.
m
Z
r-
Lt_
T
REMOVE THE MOUNTING PI]-&:
1. Remove any shipping materials and parts from inside
the microwave oven.
2. Cover the counter top or cooktop with a thick,
protective covering to protect it from damage and dirt
See Figure 10
NOTE: If you have a free-standing range, disconnect
it, move it onto a piece of cardboard or
hardboard and pull it away from the wall, so
that you ca n get closer to the upper cabinet
and back wall for easier measuring and
drilling.
3. R emove mounting plate 2 screws from the mounting
plate as shown and discard them.
(See Figure 11)
4. The mounting plate will also be used to locate and
mark the mounting holes on the rear wall.
5. Locate exhaust adaptor, grease filters and hardware
packet.
6. At this point, remove any adhesive tape (if there is
any), on the exhaust adaptor, the grease filters and
the power supply cord.
A thick, protective
covering
/
Figure 10
i
_ _Mounting plate
Jl--
"-M°"euntingplate
12rs% r'V%ws )
--Control Panel Side
Figure 11
ROOM VENTED INSA-LLATION:
GotoSTEP 4, PREPARE THE WALL AND UPPER
CABINET FOR INSTALLATIOitbcated on page 13.
10