Tools You Will Need - Kenmore 79097602301 Installation Instructions Manual

2. Tools You Will Need
For leveling legs and Anti-Tip Bracket:
° Adjustable wrench or channel lock pliers
° 5/16" Nutdriver or Flat Head Screwdriver
° Electric Drill & 1/8" Diameter
Drill Bit (Masonry Drill Bit if
installing in concrete)
° Level & Measuring Tape
For electrical supply connection:
° 1/4" & 3/8" Socket driver or Nutdriver
Additional Materials You Will Need:
° Power Supply Cord or
° Copper Electrical Wiring & Metal
Conduit (for hard wiring)
3. Anti-tip Bracket Installation instructions
important Safety Warning
To reduce the risk of tipping of the range, the range
must be secured to the floor by the properly installed
anti-tip bracket and screws packed with the range.
Failure to install the anti-tip bracket will allow the
range to tip over if excessive weight is placed on an
open door or if child climbs upon it. Serious injury
might result from spilled hot liquids or from the range
itself.
if range is ever moved to a different location, the
anti-tip brackets must also be moved and installed
with the range.
Instructions are provided for installation in wood
or cement floor. When fastening to floor, be sure
that screws do not penetrate electrical wiring or
plumbing.
Tip Over Hazard
* Ensure the anti=tip device is re-engaged to floor
or wall when the range is moved.
* Do not operate the range without the anti-tip
device in place and engaged.
* Failure to follow these instructions can result in
death or serious burns to children and adults.
* A child or adult can tip the range
and be killed.
* Verify the anti-tip device has
been installed to floor or wall.
A. Lacate the Bracket Using the Template = Locate
the bracket position (right or left side) by placing
the template symmetrically to the center of the final
range position. Mark the location of the screw holes,
shown on template.
Figure |
B. Drlll Pilot Hales and Fasten Bracket - Dritt a 1/8"
pilot hole where screws are to be located. If bracket
is to be mounted to the wall, drill pilot hole at an
approximate 20 ° downward angle. If bracket is to
be mounted to masonry or ceramic floors, drill a
3/16" pilot hole 1-3/4" deep. The screws provided
may be used in wood or concrete material. Use a
5/16" nut-driver or flat head screwdriver to secure
the bracket in place.
FASTEN BRACKET
(WALL OR FLOOR MOUNTING)
"-_1 I_P-= 1 -1/4" Max.
Leveling leg _ i
i
i
mount
FASTEN BRACKET
(FLOOR MOUNTING ONLY)
==_1 I,q =.=More than
Leveling leg _ \ 1-1/4"
ii
- Bracket
Figure 2