Battery Details - WowWee Robosapien X User Manual

Battery Details

BATTERY REQUIREMENTS:
Your robot is powered by 4 x "D" size Alkaline batteries (2 batteries in each foot - not included).
Your remote controller is powered by 3 x "AAA" batteries (not included).
Your infra-red dongle is powered by 3 x "LR44" batteries (included).
BATTERY INSTALLATION:
• Be sure the robot power button is in the OFF position (OUT) before installing or changing batteries.
• Remove the battery covers with a Phillips/crosshead screwdriver as shown (not included).
• Install recommended batteries as shown, making sure battery polarity is correct (batteries not included).
• Replace battery doors and carefully tighten all screws.
1.5V
"D"
LR20
UM1
Robosapien X™ : Base of feet
IMPORTANT BATTERY INFORMATION:
• Use only fresh batteries of the required size and recommended type
• Do not mix old and new batteries, different types of batteries [standard
(Carbon-Zinc), Alkaline or rechargeable] or rechargeable batteries of
different capacities
• Remove rechargeable batteries from the toy before recharging them
• Rechargeable batteries are only to be charged under adult supervision
• Please respect the correct polarity, (+) and (-)
• Do not try to recharge non-rechargeable batteries
• Do not throw batteries into the fire
• Replace all batteries of the same type/brand at the same time
• The supply terminals are not to be short-circuited
• Remove exhausted batteries from the toy
• Batteries should be replaced by adults
• Remove batteries if the toy is not going to be played with for some time
LOW BATTERY INDICATORS:
When Robosapien X™ 's batteries grow weak, your Robosapien X™ will move and walk very slowly.
- When this occurs, power robot OFF and replace all batteries.
When the remote controller's batteries grow weak, the indicator light will shine very dimly.
- When this occurs, replace all the batteries in the remote controller.
NOTE
• Robot will just stop when battery power gets VERY low. Power off and replace all batteries.
• Some lighting or sunlight can interfere with infra-red signals.
P.3
1.5V
1.5V
"D"
"D"
LR20
LR20
UM1
UM1
1.5V
"D"
LR20
UM1
Infra-Red Dongle
1.5V "AAA"
LR03 UM4
1.5V "AAA"
LR03 UM4
1.5V "AAA"
LR03 UM4
Remote Controller:
Bottom View