WowWee Robosapien X User Manual page 15

Robosapien X™ can be set up as a "Room Guard" or can even start
dancing to your favorite music using the built-in Sonic Sensor Program
function.
Sonic Sensor Programs
a
Ensure the Controller is in the Normal Command Mode
(indicator light on the Controller is DARK).
b
Press the Sonic Sensor Program button
( ) once; Robosapien X™ says
"BEEP!". You are now in Program Entry
Mode.
c
Program up to SIX steps (the SELECT
button does not count as a step).
• For example:
WALK FORWARD, RIGHT ARM OUT, STOP,
( , , ROAR),
SELECT SELECT
TILT BODY RIGHT, TILT BODY LEFT.
After six steps, Robosapien X™ will
automatically repeat your programmed
sequence so you can check what it will do.
d
If you wish to program less than six steps, you need to 'Close' the program by pressing
PROGRAM PLAY (
WALK FORWARD, (
SELECT
e
To review your program again, press SELECT once (Controller indicator light goes GREEN),
followed by Sonic Sensor button. Robosapien X™ will run through your routine.
f
To put Robosapien X™ into SONIC RESPONSE mode, press SELECT followed by LISTEN.
He'll now wait for a sharp sound or tap on his body, then run through your programmed routine.
Clearing the Program/Holding the Program
a
To clear the Sonic Program and return to the Default Program, press the Sonic Program button
once, then PROGRAM PLAY.
b
Turning Robosapien X™ off will also clear any previously set programs.
c
Use the Sleep function ( SELECT, SLEEP ) to hold the program in Robosapien X™ 's memory for
up to two hours.
) after you've completed your selection - for example:
, , HIGH 5), WALK BACKWARDS, PROGRAM PLAY.
SELECT
Programming Mode
SELECT SELECT
sonic sensor
SLEEP SLEEP LISTEN LISTEN
STRIKE 2 STRIKE 2 STRIKE 2 STRIKE 2
SELECT SELECT
P.14