Programming Mode - WowWee Robosapien X User Manual

Programming Mode

touch sensors
Robosapien X™ has three programmable sensors and a Master Program, that
allows you to take control of the following unique programming environments:
1 Right Sensor Program (
2 Left Sensor Program (
3 Sonic Sensor Program (
4 Master Program (
Touch Sensors
The sensors on Robosapien X™ 's Fingers,
Toes and Heels can all be programmed to
respond when touched. They also trigger
whenever he walks into an obstacles.
Right & Left Sensor Programs
a
Ensure the Controller is in Normal Mode
(indicator light on Controller is DARK).
b
Press the Right or Left Sensor Program button once
(Robosapien X™ beeps - you are now in Program Mode).
c
Program up to six steps (the Select button does not count as step). For example:
Walk Forward, Right Arm Out, Left Arm Out, (
d
Robosapien X™ will now automatically repeat your programmed sequence.
e
If you wish to program less than six steps, you need to 'Close' the program by pressing
PROGRAM PLAY (
Walk Forward, Turn Right, (
f
To trigger the sensor, touch a long finger, or a toe/heel sensor (on the side corresponding to the
Sensor Program you set). Alternatively press SELECT once (GREEN command mode), followed by
R> or L> Sensor Program Execute (depending on which side has been programmed) and he'll also
run through the routine.
Clearing the Program/Holding the Program
a
To clear the program and return to the Default Program, press the Right, or Left Sensor Program
button once, followed by the Program Play button and the program will clear.
b
Turning Robosapien X™ off will also clear any previously set programs.
c
Use the Sleep function to hold the program in Robosapien X™ 's memory for up to two hours.
P.13
) #16
) #18
) #17
) #19
SELECT
) once, after you've completed your selection - for example:
, ) High 5, PROGRAM PLAY (
SELECT SELECT
SELECT SELECT
, ROAR), Tilt Body Right, Tilt Body Left.
,
SELECT
).
SLEEP SLEEP LISTEN LISTEN
STRIKE 2 STRIKE 2 STRIKE 2 STRIKE 2
SELECT SELECT