Iforget Password (Reset The Router Without Login ); Ihave Some Problems Related To Connection With Cable Modem; Ican Browse The Router; Internet - Netis WF-2403 User Manual

6.2. I forget Password (Reset the Router without Login)

Use a pencil to press the button for about 2-6 seconds when it is working, then leave your
hands, it will restore settings to the factory configuration. The default password is guest.
6.3. I have some problems related to Connection with Cable Modem
Please follow the following steps to check the problems:

Check whether the DSL modem works well or the signal is stable. Normally there will be
some indicator lights on the modem, users can check whether the signal is ok or the
modem works well from those lights. If not, please contact the ISP.

Check the front panel of the Router, there are also some indicator lights there. When the
physical connection is correct, the Power light and the CPU light should be solid; the
WAN light should be blinking. If you use your computer, the corresponding LAN port
light should be blinking too. If not, please check whether the cables work or not.

Repeat the steps in WAN Setup Connect with Internet through DSL Modem.
I can browse the router's Web-based Configuration Utility but cannot access
6.4.
the Internet.

Check if the WAN LED is ON. If not, verify that the physical connection between the
router and the DSL/Cable modem is firmly connected. Also ensure the DSL/Cable modem
is working properly.

If WAN LED is ON, open the System Overview page of the Web configuration utility and
check the status group to see if the router' s WAN port has successfully obtained an IP
address.

Make sure you are using the correction method (Dynamic IP Address, PPPoE, or Static IP)
as required by the ISP. Also ensure you have entered the correct settings provided by the
ISP.

For cable users, if your ISP requires a registered Ethernet card MAC address, make sure
you have cloned the network adapter' s MAC address to the WAN port of the router. (See
the MAC Address field in WAN Setup.)
6.5.

My wireless client cannot communicate with another Ethernet computer.


Ensure the wireless adapter functions properly. You may open the Device Manager in
Windows to see if the adapter is properly installed.

Make sure the wireless client uses the same SSID and security settings (if enabled) as the
Portable Wireless-N Router/AP User Manual
57