Haier AS072XVERA Operation And Installation Manual page 29

Instructions to installation
Lid for right piping
Lid for under piping
Fix with adhesive tape
7. Other direction piping
Cut away, with a nipper, the lid for piping according to the piping direction and then bend the
pipe according to the position of wall hole. When bending, be careful not to crash pipes.
Connect beforehand the indoor/outdoor electric cable, and then pull out the connected to the heat
insulation of connecting part specially.
Hang surely the unit body onto the upper notches of the mounting plate. Move the body from
side to verify its secure fixing.
In order to fix the body onto the mounting plate, hold up the body aslant from the underside
and then put it down perpendicularly.
The distance between the signal wires and the power cabes should be at least 50mm.
Indoor unit D
Please refer to the indoor unit installation manual to find detailly how to set and check the communication
address.
Lid for left piping
Indoor unit C
C1 C2 C1 C2
Communication cable (Shield wire): H05RN-F 2X1.5mm
Connecting cable : H05RN-F 3G 2.5mm
Heat insulation
material
signal wire
Drain hose
Indoor/outdoor
electric cable
Indoor/outdoor electric cord and drain hose must
be bound with refrigerant piping by protecting tape
Indoor unit B Indoor unit A
L N
To the outdoor unit
27
Piping
Change-f or-fresh-air tube
C1,C2
2
2