Weslo Pursuit E40 Bike User Manual page 6

4. Connect the wire harness on the Handlebar (5) to
the indicated wire harness on the Console (7). Insert
both wire harnesses into the opening in the bottom
of the Console. Then, insert the metal tube on the
Handlebar into the opening in the bottom of the
Console. Be careful not to pinch the wire har-
nesses.
See the inset drawing. Tighten an M4 x 16mm
Screw (9) into the indicated bracket on the Console
(7) and into the metal tube on the Handlebar (5).
Snap the bookrack onto the Console (7) in the loca-
tion shown.
5. While another person holds the Console (7) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (10). Insert the
excess wire harness into the Handlebar Post (14).
Attach the Console (7) to the Handlebar Post (14) with
three M10 x 27mm Button Screws (8) and three M10
Split Washers (41). Be careful to avoid pinching the
wire harnesses.
6. Press the Side Shield Cover (40) onto the Left and
Right Side Shields (1, 2). Make sure that the four
tabs (A) on the Side Shield Cover snap into the Side
Shields.
Insert the Seat Post (20) into the Frame (15), and
press the Seat Post Bushing (23) down into the
Frame. Next, align one of the holes in the Seat Post
with the hole in the Frame. Insert the Seat Knob
(29) into the Frame and the Seat Post, and tighten
the Seat Knob into the Frame. Make sure to insert
the Seat Knob through one of the holes in the
Seat Post; do not insert the Seat Knob under the
Seat Post.
Attach the Seat (19) to the Seat Post (20) with four
M8 Nylon Locknuts (21) and four M8 Split Washers
(49). Note: The Nylon Locknuts and Split Washers
may be pre-attached to the bottom of the Seat.
4
Bookrack
7
Wire Harness
5
7
Wire Harness
10
8
41
8
6
40
A
1
6
5
9
7
Bracket
Metal Tube
5
Be careful
to avoid
8
pinching
the wire
41
harnesses.
14
19
2
49
49
21
21
20
29
23
15