Assembly - Weslo Pursuit E40 Bike User Manual

ASSEMBLY

Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed.
Assembly requires the included allen wrench
adjustable wrenches
1. While another person holds the Handlebar Post (14)
in the position shown, connect the Upper Wire
Harness (10) to the Lower Wire Harness (11).
Carefully slide the Handlebar Post onto the Frame
(15). Be careful to avoid pinching the Wire
Harnesses. Attach the Handlebar Post with three
M8 x 27mm Button Screws (37) and three M8 Split
Washers (49).
2. Identify the Front Stabilizer (17), which has a Wheel
(25) on each end.
Hold the Front Stabilizer (17) against the saddle on
the front of the Frame (15). Attach the Front
Stabilizer with two M8 x 90mm Carriage Bolts (30)
and two M8 Nylon Locknuts (21).
Attach the Rear Stabilizer (not shown) in the same
manner.
3. The Console (7) requires four "D" batteries (not
included); alkaline batteries are recommended.
Press the tab on the battery cover, and lift off the
battery cover. Insert four batteries into the battery
compartment. Make sure that the batteries are
oriented as shown by the diagram inside the
battery compartment. Reattach the battery cover.
, a phillips screwdriver
.
5
1
49
37
10
11
15
2
17
30
25
3
Battery
Cover
Batteries
, and two
14
37
49
37
25
15
21
Tab
7