ILLUSTRATED PARTS LIST
PART NO.
99-5027
99-5057
99-5056
99-5052
99-5058
99-5020
99-5035
10-0633
99-6176
99-6177
4200/4292 REVERSING SWING OF DOOR (S):
1.
Remove door handle, P/N 08-5205, by removing three slotted screws located on
edge of handle.
2.
Loosen two upper hinge pin screws. Pin will drop into door.
3.
Remove door by tilting top of door outward while lifting door off of lower hinge pin.
4.
Remove catch plate assembly from face of oven.
5.
Remove four round head machine screws from opposite side of oven face.
6.
Re-install on other side of oven face, the four round head machine screws removed
in step 5.
7.
Re-locate and install catch plate assembly at new location.
8.
Hold door in new position and allow hinge pin to slide out. Tighten two screws to
hold pin in this position.
9.
Release the (new) top hinge pin and re-install door in the new position. Push up
hinge pin and tighten two screws to hold upper hinge pin in place.
10.
Replace handle using hardware removed in step 1.
11.
Adjust door by resetting adjustment on catch plate assembly.
INSIDE OVEN COMPARTMENT
DESCRIPTION
BAFFLE
RACK SUPPORTS
RACKS
EXTERIOR TOP PANEL
EXTERIOR REAR PANEL
RIGHT SIDE ACCESS PANEL
LEFT SIDE PANEL
4" ADJUSTABLE LEGS
28" HIGH STAND
18" STACKED KIT WITH STAND
18