Installing Your Phone; Connecting The Base Station; Installing And Charging The Batteries - iDect Link Plus Single User Manual

2

INSTALLING YOUR PHONE

2.1

Connecting the base station

1) Plug the power supply
into the base station.
2) Plug the power adapter into a 230Vac,
50Hz mains socket,
your telephone line socket.
3) Always use the cables provided in the box
Warning: Use only the provided adaptor, using
other power supplies may cause a hazard.
Warning: Install the base unit in a position where the mains adapter plug
will reach an easily accessible mains socket. Never try to lengthen the
mains power cable.
Note: The base unit needs mains power for normal operation, not just for
charging the handset batteries.
2.2

Installing and charging the batteries

1) Place the 2 supplied batteries into the battery
compartment with the polarity markings as shown
Use only the NiMH rechargeable battery type provided.
2) Position the battery compartment cover over the
batteries and slide up to click into place.
3) Put the handset on the base and charge for
15 hours before using the handset for the first time.
The handset will give a beep when it is properly placed on the base or
charger.
If you have a Broadband line
If you connect your telephone to a line with
a broadband connection, you will need to
insert a micro-filter between the telephone
and the telephone line, otherwise you may get
interference between the telephone and the broadband,
which could cause problems.
In a home with broadband, every telephone must have a micro-filter connected,
not just the one at the telephone point that your modem is connected to.
If you need more broadband micro-filters, contact your broadband supplier.
and line cord
and the line cord into
5