Power Connector Cable - HP G4 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Optical drive (see
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the power connector cable (2) from the clip built into the base enclosure.
3. Remove the power connector (3) from the clip built into the base enclosure.
Reverse this procedure to install the power connector cable.
Battery on page 48), and then remove the following components:
Optical drive on page
Hard drive on page 51)
Keyboard on page 56)
Top cover on page 59)
49)
Component replacement procedures
Spare part number
639443-001
71