Scheduler Association; Bandwidth Utilization - Cisco Small Business WAP551 Administration Manual

Wireless

Scheduler Association

Scheduler Association
STEP 1
STEP 2
STEP 3

Bandwidth Utilization

STEP 1
STEP 2
STEP 3
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
The Scheduler profiles need to be associated with the WLAN interface or a VAP
interface to be effective. By default, there are no Scheduler profiles created, and
no profile is associated with any radio or VAP.
Only one Scheduler profile can be associated with the WLAN interface or each
VAP. A single profile can be associated with multiple VAPs. If the Scheduler profile
associated with a VAP or the WLAN interface is deleted, then the association is
removed.
To associate a Scheduler profile with the WLAN interface or a VAP:
Select Wireless > Scheduler Association in the navigation pane. For WAP561
devices, select the Radio interface on which you want to associate a scheduler
profile (Radio 1 or Radio 2).
For the WLAN interface or a VAP, select the profile from the Profile Name list.
The Interface Operational Status column shows whether the interface is
currently enabled or disabled.
Click Save. The changes are saved to the Startup Configuration.
Use the Bandwidth Utilization page to configure how much of the radio bandwidth
can be used before the WAP device stops allowing new client associations. This
feature is enabled by default.
To change bandwidth utilization settings:
Select Wireless > Bandwidth Utilization in the navigation pane.
Click Enable to enable Bandwidth Utilization, or uncheck Enable to disable
bandwidth utilization.
If bandwidth utilization is enabled, in the Maximum Utilization Threshold box,
enter the percentage of network bandwidth utilization allowed on the radio before
the WAP device stops accepting new client associations.
5
83