Cisco Small Business WAP551 Administration Manual page 9

Getting Started
Using the Access Point Setup Wizard
STEP 16
STEP 17
STEP 18
STEP 19
STEP 20
STEP 21
STEP 22
STEP 23
STEP 24
STEP 25
STEP 26
STEP 27
STEP 28
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
For the WAP561 device, the Network Name, Wireless Security, and VLAN ID
pages show to enable configuring Radio 2. When finished with configuring Radio
2, click Next.
The Wizard displays the Enable Captive Portal - Create Your Guest Network
window.
Select whether or not to set up an authentication method for guests on your
network, and click Next.
If you click No, skip to
If you click Yes, the Wizard displays the Enable Captive Portal - Name Your Guest
Network window.
Specify a Guest Network Name for Radio 1. For the WAP561 device, select
whether the guest network uses Radio 1 or Radio 2.
Click Next. The Wizard displays the Enable Captive Portal - Secure Your Guest
Network window.
Choose a security encryption type for the guest network and enter a security key.
For a description of these options, see
Click Next. The Wizard displays the Enable Captive Portal - Assign the VLAN ID
window.
Specify a VLAN ID for the guest network. The guest network VLAN ID should be
different from the management VLAN ID.
Click Next. The Wizard displays the Enable Captive Portal - Enable Redirect URL
window.
Select Enable Redirect URL and specify a fully qualified domain name or IP
address in the Redirect URL field (including http://). If specified, guest network
users are redirected to the specified URL after authenticating.
Click Next. The Wizard displays the Summary - Confirm Your Settings window.
Review the settings that you configured. Click Back to reconfigure one or more
settings. If you click Cancel, all settings are returned to the previous or default
values.
If they are correct, click Submit. Your WAP setup settings are saved and a
confirmation window appears.
Click Finish. The Getting Started window appears.
STEP 25.
System Security.
1
8