Status and Statistics
System Summary
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
•
Serial Number—The serial number of the Cisco WAP device.
•
Base MAC Address—The WAP MAC address.
•
Firmware Version (Active Image)—The firmware version number of the
active image.
•
Firmware MD5 Checksum (Active Image)—The checksum for the active
image.
•
Firmware Version (Non-active)—The firmware version number of the
backup image.
•
Firmware MD5 Checksum (Non-active)—The checksum for the backup
image.
•
Host Name—A name assigned to the device.
•
System Uptime—The time that has elapsed since the last reboot.
•
System Time—The current system time.
•
The TCP/UDP Service table shows basic information about protocols and
services operating on the WAP.
•
Service—The name of the service, if available.
•
Protocol—The underlying transport protocol that the service uses (TCP or
UDP).
•
Local IP Address—The IP address, if any, of a remote device that is
connected to this service on the WAP device. All indicates that any IP
address on the device can use this service.
•
Local Port—The port number for the service.
•
Remote IP Address—The IP address of a remote host, if any, that is using
this service. All indicates that the service is available to all remote hosts that
access the system.
•
Remote Port—The port number of any remote device communicating with
this service.
•
Connection State—The state of the service. For UDP, only connections in
the Active or Established states appear in the table. The TCP states are:
-
Listening—The service is listening for connection requests.
2
13