Honda 08E51-S01-101F Installation Instructions Manual page 7

23. Locate the 4-pin and 6-pin connectors blue-taped to
the vehicle harness behind the fuse box.
24. Locate the 4-pin connector blue-taped to the vehicle
harness above the fuse box, and remove the tape to
free the connector. Plug the 4-pin relay into the 4-pin
connector you just freed, then secure the relay to
the vehicle harness with the wire tie.
25. Locate the 6-pin connector blue-taped to the vehicle
harness above the fuse box, and remove the tape to
free the connector. Remove the short connector from
the 6-pin connector, and plug the 6-pin relay from the
kit into the 6-pin connector. Secure the relay to the
vehicle harness with the wire ties.
SHORT
CONNECTOR
(Discard.)
VEHICLE
6-PIN
CONNECTOR
6-PIN
RELAY
4-PIN
RELAY
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
4-PIN AND 6-PIN
CONNECTORS
WIRE TIES
BLUE
TAPE
VEHICLE
4-PIN
CONNECTOR
BLUE TAPE
26. Install the upper steering column cover. Locate
the 2-pin connector blue-taped to the vehicle
harness, and remove the blue tape to free the
connector. Get the resistor supplied with the
attachment kit, plug one end of the resistor into
the 2-pin connector you just freed and the other
end into the 2-pin connector from the LED.
UPPER STEERING
COLUMN COVER
SHORT
WIRE TIE
2-PIN
CONNECTOR
28. Install the lower steering column cover. Do not
pinch the LED harness with the cover.
27. Tape the resistor to the vehicle harness using
electrical tape. Secure the LED harness to the
vehicle harness with the three short wire ties in
the areas shown.
AII 20456 (9908)
LED 2-PIN
CONNECTOR
RESISTOR
SHORT
WIRE TIE
2-PIN CONNECTOR
VEHICLE HARNESS
ELECTRICAL
TAPE
7 of 8