Samson Airline AX1 Owner's Manual page 14

Samson AirLine
6. Make the physical cable connection between the receiver output jack and a mic or line level audio input of your camera or mixer
(see wiring diagram on page 19 for options). Be sure to set the receiver's Line/Mic switch correctly (see pages 4 for details). Leave
your camera (and/or mixer) off at this time.
7. Slide the Power switch in the direction of the arrow to turn on the receiver. The "Power/ RF" LED will light red momentarily.
8. Turn on the power to your transmitter (using its Power on-off switch); the "Power/Battery" LED will flash if the battery is sufficient-
ly strong (if it lights steadily, the battery has less than 2 hours of power remaining and should be replaced). The "Power/ RF" LED
on the receiver should light green, indicating that it is receiving valid RF signal and is placed and positioned correctly.
SAMSON
Setting up and Using your AirLine System
9. Now it's time to set the audio levels. Turn on your
connected camera and/or mixer but keep its volume
all the way down. If you are using an AL1 transmit-
ter, make sure that it is unmuted (its Mute switch
should be positioned away from the arrow). If you
are using an AL1 transmitter with the built-in micro-
phone, note that correct placement is critical to
sound quality. We recommend that you place it as
shown in the illustrations on this page—unobstruct-
ed by clothing and either clipped to a shirt pocket
or lapel, or worn around the neck on the supplied
lanyard.
12
SAMSON